Operation menu is very simple and easy understanding. There are no many page and windows. You can understand minimum screen with one sight. This has opening of DXF/DDES file and saving all data as instructed and trouble shooting data. If you have some troubles, you can send data by email to get advice from us.
Intelligent table is very simple and smart. You can calibrate rule data easily ON THE JOB. When you correct angle of arc and hope to get it again, you can teach this angle into table. If there is no correction angle, this teaching arc is created in the table.
Nicking instruction is only inputting the pitch. C shape of right drawing has each three 40mm(1.57”) length line. When you input 10mm(0.35”), this line has 4 nicks by 10 mm pitch. When you input 20mm(0.77”), this line has 2 nicks by 20mm pitch. When you input the 30, this line has one nick in the middle. (Small blue circle in the drawing means nick point) You can increase the nick quantity to edit the table cell to add “d” or “t”. “d” means double nicks. “t” means triple nick. When you input “30” at the bottom cell, this means all instructed lines with straight line and arc line have 30 mm pitch nicks at all lines.
Cross section of two nipper unit dies is shown on the instructed data. (Blue lines at the end of instructed line in the right drawing) You can see and understand the tool interfere on the display before excursion. You can prevent from tool interfere.
Controller unit, feeding unit, bridge unit, nick unit and two nipper unit is independent. If there is some problem of each, you can replace it by your self.

TOSHI BENDER62 top | tool | invisible nick | easy operation